- Steel or Aluminum
- 2005+ Tacoma / All Configurations
- 33lbs for Steel & 16lbs for Aluminum
2005-2020 TACOMA STEEL GAS SKID INSTALLATION
Installation should be done with ¼ tank of gas or less, the tank expands and makes it more difficult to get the nuts started. Remove the factory plastic skid (TRD Off Road Models). The (4) nuts will be reused for the new skid plate. NOTE: If you do not have a factory skid you will need to purchase new gas tank hanger straps for the TRD Off Road model, they have the necessary studs required for installation. Lift Gas-skid with a jack and align the studs with the 4 mounting holes. You may need to apply pressure with the jack near the studs to allow enough stud to be exposed to g et the nut started. Once all of the nuts are in place you can install the front bolts (provided 3/8? hardware) There is a custom washer plate that goes on top of the cross-member that the bolts go thru. Add the washers and nuts and tighten. Final tightening: Work your way around the skid tightening up t he bolts evenly.