2005 to 2020  Tacoma Shock Relocation Kit with 12" stroke KING shocks with Remote Reservoir Group buy

2005 to 2020 Tacoma Shock Relocation Kit with 12" stroke KING shocks with Remote Reservoir Group buy

review
0
0
5
Your Price: $793.00
Retail Price:$890.00
Your Savings:$97.00(11%)
up to a 4 to 8 week lead time for the shocks
Free Shipping
Part Number:14-2

Choose Options

Options
DIY
Welded [+$65.00]
Shock Options
KING SHOCKS 2.0 PERFORMANCE RACE SERIES SMOOTH BODY REMOTE RESERVOIR 12 INCH TRAVEL PR2012-SS
KING SHOCKS 2.0 PERFORMANCE RACE SERIES SMOOTH BODY REMOTE RESERVOIR 12 INCH TRAVEL WITH ADJUSTER PR2012-SS-A [+$199.95]

Here is the BAMF 05 to 20 rear shock relocation kit that allows you to run 12" shocks. When lifting your truck your stock mounting locations are not spaced out enough to allow a shock that doesn't act as a limit strap. This kit completely removes the stock mounting locations and replaces them with 1/4" plate. We have been selling this kit for nearly six years with hundreds of guys running them and loving it. It's simple cost effective and proven over the years in countless applications from rock crawlers, Expo rigs to prerunners.  

We have teamed up with Down south motor sports to offer you a Group buy discount on a relocation kit and a set of KING smooth body shocks with or without adjusters. Ordering here is a only way to get this pricing and it's limited to 25 orders. 




KING shocks  KING Part# PR2012-SS    12.0" stroke     31.585" Extended Length    19.585" Collapsed Length    7/8" Shaft Dia




What the kit contains if you have less please contact us 
attachFull1559539 


To start on the install fit up the parts and tack everything together. (note) if you ordered out welded set disregard this step. 
 attachFull1559541 attachFull1559542 attachFull1559543 attachFull1559544 attachFull1559545 attachFull1559546  attachFull1559548  



After tacking the buckets fully welded all seems and let cool you can not take this time to start cutting off your stock mounts. 
attachFull1559555 attachFull1559556 




Then tack the mounts to the frame and axle. The shocks are best mounted and 90* from side to side and 10 degrees leaning forward. Just use a angle finder to check the angle of the shock when tacking in place. 

The best way to mock everything up is to fully brake the leaf pack down to just a main leaf and cycle the suspension to the bumps when tacking you mounts on leaving about 1" of shaft showing at full bump for compression 
"unless your bumps compress more then that you need to compensate for for the compression or you will blow your shocks on a hard hit" 

Honestly most people just measure the bump travel and set the lower mount of the shock just a little more shock shaft showing then they have bump travel.




After tacking it up It's best to cycle your suspension with the tires on to check for clearance issues. (Wheel spacers or a less back spacing wheels may be needed to clear the shock body when fully flexed out)




 

Related Items

Recently Viewed Items